After loading in my data, I’m not able to see all my data in the MLS Data form. Where is it?

After loading in your data, the MLS Data Form contains all the data which was used to create the graphs for the last two years. Data older than two years, is discarded.  That being the case, there are times where you may be unable to see all the data if the spreadsheet has been scrolled down too far.  This generally will happen if you’ve been looking at data from a previous file and then read in data from a another file which has less data.  Take a look at the graphic below.

To make sure that you can see all the data look at the row numbers to makes sure that the row numbers are sequential (rows should go from number 5, to number 6, number 7 …).  If the row numbers are not sequential you may need to move the slider (located on the right edge as show in the photo above) up. 

If the slider is too far down, you may have situations where it looks like there isn’t any data on the spreadsheet.  Again, if this is the case, move the slider on the right all the way to the top.